Page 19

20054AG

LAPTOP CASE MARK x HERE ENDING STITCH S T This is what it should look like with the box band attached in place. U V Attach the back panel by placing this section on top with right sides facing together. Precisely line up the two sections and then measure 2.0” down from top right corner on back panel (reference step “P”). Insert a pin on back panel exactly where you marked in step “T”. This will show you where to begin stitching the next step. W X At this point, case should look like this. The two ends of box band section are ready to be stitched together. Using chalk, mark the point directly across from where your stitching ended. Attach the back panel in the same manner as shown in steps P-R. Be sure to leave the 3.0” opening as done on the front panel. Match both ends together and pin in place 3.5” from top of case. This should be directly across from where the zipper/ box band met on the other side of case. Refer to step “P”. Stitch together and trim excess box band fabric with 1/2” seam allowance. INSERT PIN 2.0” 17 OCCUPATIONS Special Edition


20054AG
To see the actual publication please follow the link above