3 INSTALLING BOTTOM EXPANDER Step 1- Insert vinyl sweep(s) into groove(s) at bottom of expander and pull it to other end. See illustration for location of sweeps by model type. Step 2- Pinch ends of sweep groove(s) with pliers so sweep will not pull out (see illustration) It is very important to make sure door is centered into opening. It may be necessary to shim ! behind z-bars in order to properly center the door. 4 Vinyl sweep is packaged in hardware kit. If vinyl sweep has become kinked during shipment, place it in boiling water for 3 minutes and sweep will return to its original shape. DO NOT INSTALL bottom expander screws at this time 1 4 Slide on sweep 2 Pinch sweep channel Slide expander onto bottom of door 200 & 500 Series 074-099, 100 and 300 Series 800 Series ! Step 3- Cut off excess vinyl with scissors or a knife. Step 4- Slide bottom expander over bottom of door, pushing it onto door as far as it will go. Step 5- Do not install the screws. The screws will be installed at final adjustment on page 7. The side of expander which has slope is exterior side 4 INSTALLING DOOR INTO OPENING If Z-Bar build out (formerly called Eastern Z-Bar Adapter) is ordered, a 1⁄4" spacer has been attached to rear side of z-bar. At installation, drill 1⁄8" holes through spacer using installation holes in z-bar as a guide. ! Step 1- Tilt and center door into opening. 1 Tilt and center into opening EXTERIOR
20330AC
To see the actual publication please follow the link above