STEP-BY-STEP INSTRUCTIONS
A B
Wind a bobbin to match the top thread. Do this for each
thread to be used.
C D
Once the design is complete, remove it from the hoop and
trim as much of the stabilizer away as possible.
To start, hoop 2 pieces of wash-away stabilizer. (Due to the
number of stitches in these designs, we used a second piece
of stabilizer.)
Run the two embroidery steps of the design.
Be sure to change to a new matching bobbin for the thread
change at the beginning of the second step!
E F
Using warm water, rinse the design to remove the stabilizer Your design is now finished. Let it SNOW!
from the snowflake. Set aside to dry on a flat surface.
LACE SNOWFLAKES | Project Collection | 110