7 8
Repeat the steps 4 - 7 to continue securing beads to the
areas you desire.
Pull the excess slack until the bead is tightly secured to the
front of the design.
9 10
When you are done adding beads, or the thread is too short,
tie off the thread on the back of the design. To do this, pierce
the needle through just the stabilizer, being sure not to go all
the way through to the front of the design.
Before pulling the excess slack through completely, a loop
will form. Slide your needle through the loop and then
continue to pull the remaining slack.
11 12
Once secured, use a pair of scissors to trim away the
excess thread.
Follow steps 3 - 11 to add more beads to your design. Once
you have added your preferred amount of beads, you are
all done!
DIY WITH ANITA | ALL ACCESS | 319