Anita’s Finishing Wonderland a Quilt || Overview
Tutorial
S T
Trim the seam allowances to ¼” and press open. Repeat until
enough binding strips are connected to measure the entire
perimeter of your quilt, plus 6” inches.
Sew using a ½” seam allowance, but stop stitching ½” from
corner then sew at a 45º angle to the edge of the binding.
Remove the quilt from your machine.
Fold the binding again. This time, align the fold in the binding
with the raw edges of the seam you just sewed and align the
raw edges of the un-stitched binding with the next edge of the
quilt. Pin in place. Starting ½” from the edge of the quilt, stitch
the binding to the next corner of the quilt.
With right sides together, lay two strips of binding perpendicular
to each other. At a 45º angle, stitch the two strips together, as
shown. Use regular sewing thread to attach the strips.
U
Starting at one of the seam lines along the side of the quilt, place
the binding along the edge. Fold the start edge back to make
a triangle, this creates a finished start and stop. Make sure that
the raw edge of the binding is aligned with the raw edge of the
quilt, right-sides together. Pin along one edge.
Fold the binding back on itself, perpendicular to the seam you
just stitched.
Anita’s Wonderland | Premium Collection | 169
V
W X