Page 5

20330AC

4 INSTALLING DOOR INTO OPENING Step 2- Hold door firmly in position and drill a 3⁄32" EXTERIOR Step 6- Check and make sure door operates properly. Step 7- With door open, locate pre-drilled mounting holes in the z-bar and drill 3⁄32" pilot holes through mounting holes and install: 5 pilot hole through very top of hinge side z-bar mounting hole and install (1) #6 x 1" screw. DO NOT OVERTIGHTEN SCREWS Step 3- Using a level, make sure z-bar runs straight up and down, then drill and install remaining screws. Fasten using #6 x 1" Phillips Panhead Screws at each end. Header Z-Bar Brickmold Install (1) #6 x 1" Phillips panhead screw Hold hinge z-bar tight against brickmold 3 Step 4- Holding z-bar header in place, drill a 3⁄32" pilot hole into top trim board or brickmold through header mounting hole, maintaining approximately 1⁄8" clearance between z-bar header and door. Step 5- Fasten header firmly in place using #6 x 1" screws. 5 ATTACHING HEADER Z-BAR ATTACHING HINGE SIDE Z-BAR Swing door open and install screws in pre-drilled mounting holes 2 7 For Leaf Hinge: For Piano Hinge: (1) pk #8 x 11⁄2" Phillips Truss Head Screws (1) pk #7 x 1" Phillips Panhead Screws EXTERIOR EXTERIOR 2 ENTRY DOOR


20330AC
To see the actual publication please follow the link above