Shown Actual Size**
15° Pin and
Fine Wire Cutter
Item #: OT-1000
The tips are angled 15o for a better field
vision and to improve access. The tool
steel inserted tips have backing ledges
for greater strength. Cuts soft wire up
to .015", pins and elastics.
Hard Wire Cutter
Item #: OT-1000HWC
Specially designed for hard wires. The
cutting angle is 15o and the edge has
been diamond honed to allow cutting
hard wire up to .020" round.
Pin and
Ligature Cutter
Item #: OT-1001
This cutter plier is standard sized
with sharp cutting edges designed to
cut soft wires up to .015", pins and
ligatures. The cutting angle is 7o.
Compact design.
Lifetime Warranty
Falcon Orthodontic Instruments include a lifetime warranty against
materials defects and craftsmanship. Cutting instruments and
wire benders are guaranteed for seven years and utility pliers for
ten years. This covers breakage and joint failure under normal
use. Sharpening cutters and/or repairing minor tip damage is not
covered by warranty as this is considered to be routine maintenance
for normal use.
Stainless Steel Inserts
Ensure clean wire cuts every time
Balanced Joint Assembly
Sliding lock joints are factory adjusted for precise long lasting
tip alignment
Ergonomic Handle
Creates excellent balance and a sure grip
• Surgical Grade Stainless Steel
• Highly Corrosion Resistant
• Diamond Honed Edges
• Precise Tip Alignment
1 per pack
Heat sterilizable up to 370°F/188°C
© 2018 Ortho Technology, Inc. Falcon Orthodontic Instruments is a registered trademark of
Ortho Technology. **Pin and Ligature Cutter Item #: OT-1001
182
ORTHODONTIC INSTRUMENTS
Instruments