Accessories
Wireless Remote Comes Preprogrammed
Installation
1.) Connect Out Put 1 to Power Unit
2.) Mount Wireless receiver
a. Select desired mounting location preferably in a sealed box and out of harms
way
b. Antenna must be mounted outside, not in metal box.
3.) Connect Positive (Red) & Negative (Black) Ring Terminals to Power Unit not
Battery
a. Insure Power Unit has a designated ground wire
4.) Operate wireless unit to insure Unit is operating properly
Function
1.) This device is activated by pushing either button 1 or 2 to power the unit.
2.) 20 Minute shut off (receiver shuts down after being idle for 20 minutes)
a. Press both buttons 1 & 2 for 10- 20 seconds to end Shutdown Mode
b. When in Shutdown Mode, Wireless receiver is the only item shutdown, Out Put 2
is still active
3.) Operating Frequency: 315MHz
How to operate the Remote Learning mode
1.) Remove wired hand control to prevent accidental operation.
2.) Disconnect Positive (Red) & Negative (Black) Ring Terminals
3.) Place Programming Sleeve (Shunt) on Pin 1 and Pin 2, to activate
Programming Mode. Fig. 2,3,4
4.) Reconnect Positive (Red) & Negative (Black) Ring Terminals (Receiver will
click)
5.) Press either button 1 or 2 (receiver will click 2 to 9 times depending on how long
you hold the button down)
6.) Replace program pin on the receiver to end Learning Mode.
(When in learning mode Remote Unit must be operated within 3-5 seconds to learn
new code. Otherwise the
device will jump back and resume previous frequency.) Unit may not operate
below 11 Volts.
ONBOARD BATTERY CHARGER & TESTER
1. SPECIFICATIONS
ITEM DESCRIPTION
Input AC 120V, 60Hz, 0.4amp
Output DC 12V, 5 amp
Battery Cables 24 inches, 18AWG
Lead Wire 3-Prong Plug
Features LED Self-resetting circuit breaker
143
2. OPERATION
1) Connect the positive (red) cable to the positive terminal of the battery.
Connect the negative (Black) cable to the negative terminal of the battery.
2) Connect the power outlet (110VAC/60Hz) to the 3-Prong plug of the
charger.
3) The LED on the battery charger will indicate the status of the charger.