3 INSTALLING BOTTOM EXPANDER
Step 1- Insert vinyl sweep(s) into groove(s) at
bottom of expander and pull it to other
end. See illustration for location of sweeps
by model type.
Step 2- Pinch ends of sweep groove(s) with
pliers so sweep will not pull out (see
illustration)
It is very important to make sure door is centered into opening. It may be necessary to shim
! behind z-bars in order to properly center the door.
4
Vinyl sweep is packaged in hardware
kit. If vinyl sweep has become kinked
during shipment, place it in boiling water
for 3 minutes and sweep will return to its
original shape.
DO NOT INSTALL
bottom expander screws
at this time
1
4
Slide on
sweep
2 Pinch
sweep
channel
Slide expander
onto bottom of
door
200 & 500 Series
074-099, 100 and 300 Series
800 Series
!
Step 3- Cut off excess vinyl with scissors or a knife.
Step 4- Slide bottom expander over bottom of
door, pushing it onto door as far as it will go.
Step 5- Do not install the screws. The screws will
be installed at final adjustment on page 7.
The side of
expander
which has
slope is
exterior
side
4 INSTALLING DOOR INTO OPENING
If Z-Bar build out (formerly called Eastern Z-Bar Adapter)
is ordered, a 1⁄4" spacer has been attached to rear side of
z-bar. At installation, drill 1⁄8" holes through spacer using
installation holes in z-bar as a guide.
!
Step 1- Tilt and center door into opening.
1
Tilt and
center
into
opening
EXTERIOR