4 INSTALLING DOOR INTO OPENING
Step 2- Hold door firmly in position and drill a 3⁄32"
EXTERIOR
Step 6- Check and make sure door operates properly.
Step 7- With door open, locate pre-drilled mounting
holes in the z-bar and drill 3⁄32" pilot holes
through mounting holes and install:
5
pilot hole through very top of hinge side z-bar
mounting hole and install (1) #6 x 1" screw.
DO NOT OVERTIGHTEN SCREWS
Step 3- Using a level, make sure z-bar runs straight
up and down, then drill and install remaining
screws.
Fasten using
#6 x 1" Phillips
Panhead Screws at
each end.
Header
Z-Bar
Brickmold
Install (1) #6 x 1" Phillips
panhead screw
Hold hinge z-bar
tight against
brickmold
3
Step 4- Holding z-bar header in place, drill a 3⁄32" pilot hole into top trim board or brickmold through
header mounting hole, maintaining approximately 1⁄8" clearance between z-bar header and door.
Step 5- Fasten header firmly in place using #6 x 1" screws.
5
ATTACHING HEADER Z-BAR
ATTACHING HINGE SIDE Z-BAR
Swing door open
and install screws
in pre-drilled
mounting holes
2
7
For Leaf Hinge: For Piano Hinge:
(1) pk #8 x 11⁄2" Phillips
Truss Head Screws
(1) pk #7 x 1" Phillips
Panhead Screws
EXTERIOR
EXTERIOR
2
ENTRY DOOR