4 INSTALLING DOOR INTO OPENING
ATTACHING LATCH SIDE Z-BAR
Step 8- Cut and install latch side z-bar maintaining
approximately 1⁄16" clearance between door and z-bar.
Step 9- Fasten with #6 x 1" screws
9
Install
#6 x 1
screw
5 REMOVING PRE-HANG CLIPS
Caution: Do not use a tool to remove pre-hang clips, doing so may cause damage to
door slab. YOU MUST ROTATE PRE-HANG CLIP COUNTER-CLOCKWISE TO
REMOVE. !
Side View Side View
6
Remove
Pre-hang
Screw
Step 1- After door has been installed, remove (1) #8 x 1⁄4"
Phillips Panhead Screw that is installed into each of
pre-hang clips.
Step 2- Allow door to swing open.
Step 3- To remove pre-hang clips, turn pre-hang clip(see
illustration) a 1/4 turn counter- clockwise by hand.
There will be 2 pre-hang clips at top header and 3 pre-
hang clips on vertical latch side of storm door frame.
Screw Cap
Cover
Latch strike
1
The slim line z-bar application will use a slimmer pre-hang clip
and will not have “Remove” on the clip. !
Turn
counterclockwise
2
Pre-Hang Clip for Leaf or Piano Hinge Pre-Hang Clip for Slim-Line Zbar
Application Application