Eye Wash | EMERGENCY
53
Plumbed Eye Wash
Did You Know?
Eye Wash: Plumbed vs. Self-Contained
Once potential hazards have been identified, the employer must select
and install emergency eye wash units throughout the facility in locations
that require no more than 10 seconds to reach from the site of the
hazard. One important decision is the choice between plumbed eye
wash units and self-contained eye wash units. Plumbed units are
dependent upon a readily available water source and a drain, and they
become a permanent fixture that is challenging to move once installed.
Self-contained units, on the other hand, use sealed fluid cartridges or a
gravity-fed tank design which requires no plumbing. In the event of changes
within the workplace, or relocating to a new facility, self-contained units
have a unique design which allows for portability.
Factors to consider when
determining which eye wash
and drench systems are right for
your facility:
• ANSI recommends the use of a preserved, buffered saline solution
for individual-use eye wash applications.
• Consider an eye wash unit with a collection tank — it is important
that contaminated water not create its own hazard.
• The location of the unit should be in a well-lit area and identified
with a sign. Workers should not have to go up or down stairs to
access the unit.
• Consider your facility’s unique needs. For example: Do you have
workers in a remote location? What type of water supply is
available? What type of chemicals and corrosives do employees
work with? Consult with an expert to make sure your employees
are protected.
• ANSI recommends that emergency fixtures supply tepid water to
flush the eyes to avoid hypothermia or scalding. Therefore, water
temperature needs to be considered, especially if you have an
outdoor eye wash or if your facility is located in a cold area. In
such cases, consider a heated unit.
• All devices should be inspected weekly to test equipment performance
and to flush debris or bacterial sediment. If the unit uses tap water,
check the manufacturer’s instructions for replacement.
A • Halo Eye / Face Wash
With 20 percent more coverage and a superior wash pattern, Halo users
experience the most effective contaminant relief available. New ergonomic
hand activation paddle is easy to reach from any direction. Separate supply
and waste pipes to eye/face wash are an industry first and Bradley exclusive.
The Aquaduct™ design is the only self-draining design for standard eye
wash models, which helps reduce the risk of bacteria growth when unit is not
in use. Integral strainer inside the Aquaduct reduces debris in the water for
additional eye protection and also prevents clogging. Meets U.S. and European
plumbing requirements.
#0656
HALO WITH LID
#BDS19224
B • Bradley Faucet Mount Eye Wash
Mounts easily to both standard and gooseneck faucets. Highly visible yellow dust
caps are flexible plastic and pop off eye wash sprayheads when unit is activated.
Provides one step activation and meets ANSI Standard Z358.1-2004 when
installed and calibrated properly. Three adapters included.
#0653
OSHA Zone
OSHA 1910.151(c) states that where the eyes or body of any person may
be exposed to injurious corrosive materials, suitable facilities for quick
drenching or flushing of the eyes and body shall be provided within the
work area for immediate emergency use.
A m e r i c a ’ s F i r s t A i d a n d S a f e t y R e s o u r c e
#0656
#BDS19224
A
B