IMPORTANT ASSEMBLY ALERT
SUPPORTED PLATFORM
PREFERRED STAIR ASSEMBLY PROCEDURE
With the stair assembly fully assembled, properly locate the stair
unit on the pad layout anchor bolts “A”.
A) Use the closest hole “A” to the bottom edge of the stairs for
standard anchor bolt pad layout. Additional anchor bolt hole
towards the platform can be added if additional holding force
is required and for systems higher than 6 steps. Start anchor
bolt nuts so that the stairs can be adjusted but will not come
off of the anchor bolt.
B) Support the stair assembly using forklift, crane, or temporary
support (as shown in “B”). Temporary support can be built to
stand under one of the highest step treads.
C) Height of temporary support can be calculated by multiplying
the number of steps by 9”, then subtract 3/8”.
STEP 1
A
A
B
page 4