CREATING THE UTENSIL HOLDER
STEP-BY-STEP INSTRUCTIONS
A B
Run the first machine step, which is the placement stitch for
the base fabric.
C D
With wrong sides together, fold the 14” x 4.5” piece of base
fabric in half as shown here. With the folded edge on top,
lay the folded base fabric over the placement stitches, being
sure they are covered entirely.
Run the tacking stitch to secure the base fabric to the design.
NOTE: You will notice that there are marking stitches built
into this tacking stitch that show where to trim.
To begin, hoop a piece of Tear Away stabilizer and load the
TSUBACK design file.
TABLESCAPES | PROJECT | 72