3D ORNAMENTS
3D ELEMENTS STEP-BY-STEP INSTRUCTIONS
G BACK OF HOOP H BACK OF HOOP
Once trimmed completely, insert a bobbin to match the
top thread, so that the design matches on both sides.
Once complete, set the design aside, then complete
the remaining 3D elements in the group.
Run the final decorative embroidery steps to complete
the design, then remove the design from the hoop,
and remove any excess stabilizer from the design.
Once all pieces are complete and collected, you are
ready to start the main design.
TIP: Remember to match your bobbin thread
accordingly.
I
K
J
L
Place the appliqué fabric face up on top of the design.
Use tape to secure it in place, making sure that the
appliqué completely covers the entirety of the design.
The next machine step is the tacking stitch for the
appliqué. Trim away the excess fabric up to the
tacking stitch.
BACK OF HOOP