G H
Once trimmed, the back of your design should look something
like this, with the paper side of the adhesive still attached.
I J
Once the paper is removed from your design, you should see the
clear adhesive covering the entire back portion.
K L
Then center the stitched design, adhesive side down, on top of
the contrasting felt.
Carefully peel away the paper covering from the back of the
adhesive. Note that the adhesive is heat-activated, so it will not be
sticky at this step.
Cut a piece of contrasting felt approximately 1/4” larger than the
design on all sides.
Use a hot iron to fuse the stitched design to the contrasting felt.
Then repeat steps E - I to attach another piece of HeatnBond
UltraHold to the back of the patch; this will make it iron-on!
Eclectic Animals | Full Collection | 347
