ATTACHING THE 3D FLOWERS
STEP-BY-STEP INSTRUCTIONS
First, hoop a piece of Tear-Away stabilizer.
NOTE: For this hooping, you will need to load design
AFC3DFlower2.
Run the first machine step, which is a placement stitch that
shows you where to center your flower.
Use a straight pin to poke through the center of the large
flower, then stick the pin through the center of the X in the
placement stitch. Once aligned, secure the flower to the
stabilizer with tape and remove the pin.
Run the next machine step, which is the tacking stitch in the
center of the flower that secures it to the stabilizer.
THREE DIMENSIONAL | FUNDAMENTALS | 130
A
C
B
D